Keep the screws for later use. Because motherboard settings and hardware options vary, use the setup procedures in this chapter for general reference only. Please connect a CPU fan cable to this connector and match the black wire to the ground pin. Use this item to enable or disable the S. Make sure the red-striped side of the cable is plugged into Pin1 side of the connector. Make sure that the CPU and the heatsink are securely fastened and in good contact with each other. The current SATA interface allows up to 1.
|Date Added:||7 November 2016|
|File Size:||48.44 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Self-Monitoring, Analysis, and Reporting Technology feature. If the jumpers JL1 and JR1 are short, both the front panel and the rear panel audio connectors can work.
For audio output, this motherboard supports 2-channel, 4-channel, 6-channel, and 8-channel modes. The data in CMOS includes system setup information such as system password, date, time, and system setup parameters. Infrared Port Address Use this item to set the address for the onboard infrared port or disable it.
Ring-In Power On Use this item to enable or disable Ring-In signals to turn on the system from the power-soft-off mode. You also need to spray thermal grease between the CPU and the heatsink to improve heat dissipation.
Unplug the power cord from the wall socket before touching any component. To improve heat dissipation, remember to spray thermal 5. Because the BIOS software is constantly being updated, the following BIOS setup screens and descriptions are for reference purpose only, and they may not exactly match what you see on your screen.
Operation is subject to the following two conditions: Parallel Port Mode Use this item to set the operation mode of the parallel port. Keep the screws for later use. OnBoard Floppy Controller Use this item to enable or disable floppy drive controller. Supports up to 4 SATA devices at 1.
You may also restart by turning the system off and then back on. Position the CPU directly above the socket such that its marked corner matches the base of the socket lever. Do NOT place jumper caps over these headers and connectors.
You may install SATA hard disks on this motherboard for internal storage devices. Before installing the expansion card, please make sure that the power supply is switched off or the power cord is unplugged. The current SATA interface allows up to 1. Click on a specific item then follow the installation wizard to install it.
ASRock P4Dual-915GL – motherboard – micro ATX – Socket 478 – i915GL
For the detailed instruction, please refer to the document at the following path in the Support CD: If those USB 2. In no event shall ASRock, its directors, officers, employees, or agents be liable for any indirect, special, incidental, or consequential damages including damages for loss of profits, loss of business, loss of data, interruption of business and the likeeven if ASRock has been advised of the possibility of such damages arising from any defect or error in the manual or product.
Please connect a CPU fan cable to this connector and match the black wire to the ground pin.
Please connect a chassis fan cable to this connector and match the black wire to the ground pin. Dual-915bl sure that the CPU and the heatsink are securely fastened and in good contact with each other.
Please install the necessary drivers to dual-915lg the devices. Align the card connector with the slot and press firmly until the card is completely seated on the slot. This header supports an optional wireless transmitting and receiving infrared module.
ASRock > DualGL
Unlock a DIMM slot by pressing the retaining clips outward. Because motherboard settings and hardware options vary, use the setup procedures in this chapter for general reference only. Pre-installation Precautions Take note of the following precautions before you install motherboard components or change any motherboard settings.
The lever clicks on the side tab to indicate that it is locked.